Grizzly G0513P Manuel d'utilisateur télécharger pdf (Page 25)

G0513 Series Bandsaws

-23-

Installing Fence (G0513X2B &

G0513X2BF)

1. Attach the rail plates to the front rail with the

(3) M6-1 x 20 cap screws, 6mm lock wash-

ers, and 6mm flat washers (see Figure 24).

Figure 24. Installing front rail onto table.

Knob

Flat

Washer

8mm

Flat Washer 6mm

Lock Washer 6mm

Lock Washer

8mm

Front Rail

Rail Plate

Cap Screw

M6-1 x 20

Cap Screw

M8-1.25 x 20

2. Attach the outer two rail plates with the round

and elongated mounting holes to the outer

part of the table bottom with (2) M8-1.25 x 20

knobs and 8mm flat washers.

3. Attach the remaining rail plate with the round

mounting holes using (1) M8-1.25 x 20 cap

screw, 8mm lock washer, and 8mm flat

washer (see Figure 24).

4. Thread the fence handle into the fence, then

tighten the hex nut against the fence pivot

block (see Figure 25).

Figure 25. Fence handle components.

Hex Nut

Fence

Handle

5. Install the fence on the left-hand side of the

blade.

6. Place the fence flush against the bandsaw

blade (see Figure 26).

Figure 26. Fence flush with blade.

8. Re-tighten the pointer adjustment nut.

7. Loosen the pointer adjustment nut (see

Figure 27) and set the pointer in line with "0"

on the measurement scale on the rail.

Figure 27. Calibrating fence pointer

(adjustment nut out of view).

Pointer

Pointer Nut

1 2 ... 20 21 22 23 24 25 26 27 28 29 30 ... 107 108

Commentaires sur ces manuels

Pas de commentaire

Grizzly G0513P Manuel d'utilisateur Page 25

Commentaires sur ces manuels

Produits connexes et manuels pour Scies à moteur Grizzly G0513P