Grizzly G0513P Manuel d'utilisateur télécharger pdf (Page 22)

-20-

G0513 Series Bandsaws

We recommend mounting your new machine to

the floor. Because floor materials may vary, floor

mounting hardware is not included. You may also

mount your machine to a mobile base that has

wheel locking or wheel retracting capabilities that

keeps the mobile base from rolling when not in

use.

Bolting to Concrete Floors

Lag shield anchors with lag bolts (see Figure 14)

and anchor studs (see Figure 15) are two popular

methods for anchoring an object to a concrete

floor. We suggest you research the many options

and methods for mounting your machine and

choose the best that fits your specific application.

Mounting

Figure 14. Typical lag shield anchor and bolt.

Figure 15. Typical anchor stud.

Anchor studs are stronger and more per-

manent alternatives to lag shield anchors;

however, they will stick out of the floor,

which may cause a tripping hazard if you

decide to move your machine.

Assembly

Installing Guide Post Handwheel,

Positive Stop Bolt, & Table

1. Secure the guide post handwheel onto the

handwheel shaft flat with the included set

screw (see Figure 16).

Figure 16. Guide post handwheel installed.

Guide Post

Handwheel

2. Thread the M8-1.25 hex nut halfway onto the

M8-1.25 x 90 hex bolt (this is the positive stop

bolt).

3. Thread the positive stop bolt into the thread-

ed hole on bandsaw body (see Figure 17).

Figure 17. Positive stop bolt installed.

Positive Stop

1 2 ... 17 18 19 20 21 22 23 24 25 26 27 ... 107 108

Pas de commentaire

Grizzly G0513P Manuel d'utilisateur Page 22