Grizzly G9983 Manuel d'utilisateur télécharger pdf (Page 20)

-18- G9983 15" Open-End Wide-Belt Sander

Long term exposure to

this machine during

operation may cause

hearing loss. Wear

approved hearing pro-

tection to minimize this

risk!

Recommended

Adjustments

2. Start both the sanding belt and the feed belt,

making sure your finger is poised over the

STOP button, just in case there is a problem.

The wide-belt sander should run smoothly,

with little or no vibration or abnormal rubbing

noises. It is normal, however, for the air oper-

ated tracking to make a rhythmic back and

forth noise.

Strange or unnatural noises should be investigat-

ed and corrected before operating the machine

further. To avoid injury or damage to the

machine, DO NOT attempt to make adjustments

to the machine without turning it off and unplug-

ging it from its power source.

If noises occur that cannot be found by visual

inspection, feel free to contact our Service

Department for help.

For your convenience, the adjustments listed

below have been performed at the factory and no

further setup is required to operate your machine.

However, because of the many variables

involved with shipping, we recommend that you

at least check the following adjustments to

ensure the best possible results from your new

machine.

All of these adjustments are covered in step-by-

step detail in Section 8: Service Adjustments.

Recommended adjustment checklist:

• Pressure Rollers

• Oscillation Timing

• Oscillation Speed

• Oscillation Return

• Limit Switch Position

• Feed Belt Tension

• Feed Belt Tracking

• V-Belt Tension

Disconnect power to the

machine when perform-

ing any adjustments.

Failure to do this may

result in serious person-

al injury.

1 2 ... 15 16 17 18 19 20 21 22 23 24 25 ... 59 60

Commentaires sur ces manuels

Pas de commentaire

Grizzly G9983 Manuel d'utilisateur Page 20

Commentaires sur ces manuels

Produits connexes et manuels pour Machines à broyer Grizzly G9983