Grizzly G0632 Manuel d'utilisateur télécharger pdf (Page 31)

G0632 16" x 42" Variable Speed Wood Lathe

-29-

Spindle Turning

Spindle turning is the operation performed when

a workpiece is mounted between the headstock

and the tailstock (see Figure 39

Figure 39. Typical spindle turning operation.











Figure 40. Workpiece marked diagonally from

corner to corner to determine the center.

To set up a spindle turning operation:

1. Find the center point of both ends of your

workpiece by drawing diagonal lines from cor

ner to corner across the end of the workpiece

(see Figure 40).

Spindle Turning

Make sure the headstock and tailstock cen-

ters are properly aligned before beginning

any turning operation. See Aligning Centers

on Page 38 for additional instructions on

this procedure. Failure to observe this warn

ing could result in the workpiece being

thrown from the lathe resulting in serious

personal injury.

2. Using a wood mallet, tap the point of the spur

center into the center of the workpiece on

both ends, leaving an indented center mark.

3. Using a

⁄4" drill bit, drill a

⁄4" deep hole at the

center mark on the end of the workpiece to

be mounted on the headstock spur center.

1 2 ... 26 27 28 29 30 31 32 33 34 35 36 ... 55 56

Pas de commentaire

Grizzly G0632 Manuel d'utilisateur Page 31