Grizzly G0632 Manuel d'utilisateur télécharger pdf (Page 24)

-22-

G0632 16" x 42" Variable Speed Wood Lathe

Installing/Removing

Headstock Center

The included spur center installs into the head-

stock spindle with an MT#2 tapered fit.

To install the headstock center:

1. DISCONNECT THE LATHE FROM THE

POWER SOURCE!

2. If the faceplate is installed on the spindle,

remove it (see

Page 23 for detailed instruc-

tions).

3. Make sure the mating surfaces of the center

and spindle are free of debris and oily sub

-

stances before inserting the center.

4. Insert the tapered end of the center into

the spindle, and push it in with a quick, firm

motion (see

Figure 22).

5. Make sure the center is securely installed by

attempting to pull it out by hand—a properly

installed center will not pull easily.

To remove the headstock center with the

knockout tool:

1. DISCONNECT THE LATHE FROM THE

POWER SOURCE!

2. Hold a clean rag under the spindle or wear a

glove to catch the center when you remove

it.

3. Insert the knockout tool through the outbound

end of the spindle and firmly tap the center,

catching it as it falls

(see Figure 23).

Headstock Center

Make sure the headstock and tailstock cen-

ters are properly aligned before beginning

any turning operation. See Aligning Centers

on Page 38 for additional instructions on

this procedure. Failure to observe this warn

-

ing could result in the workpiece being

thrown from the lathe resulting in serious

personal injury.

Figure 22. Installing center into the headstock

spindle.

Figure 23. Removing the headstock center.

Knockout Tool

1 2 ... 19 20 21 22 23 24 25 26 27 28 29 ... 55 56

Commentaires sur ces manuels

Pas de commentaire