Grizzly H7762 Manuel d'utilisateur télécharger pdf (Page 19)

H7762 Heavy Duty Tool Grinder

-17-

Grinding Tips Operating Grinder

The grinder is a safe tool when used properly. In

addition to the safety instructions in this manual,

the most important safety consideration is to use

common sense at all times. What may be okay in

one situation, may not be safe in another.

Read and understand the following state-

ments to protect yourself before grinding:

• Make sure all guards are in place.

• Stand to the side of the grinder when you turn

it ON and allow it to run for one full minute

before beginning any grinding procedure.

• Make sure there are no loose mounting bolts

and that you have performed the “Test Run”

instructions in this manual.

• Remember that grinding often produces

sparks. DO NOT allow anyone to stand in the

path of the sparks. DO NOT grind near poten-

tially flammable materials, such as flammable

liquids or gases, paper or cloth.

• Wear the proper protective clothing.

Remember that particles flying off of a grind-

ing wheel will be traveling very fast—prepare

for this. Wear a face shield, a dust mask and

a leather apron.

• DO NOT lean into the workpiece in a manner

that may cause your hands to move into the

spinning wheel if the workpiece slips off.

• Concentrate on the task at ha

nd. STOP

grinding if there are distractions.

The grinder is designed for use with ferrous met-

als only. Grinding non-ferrous metals and wood

products will quickly load the grinding wheel sur-

face with particulate matter and ruin its abrasive

qualities. It can also cause the wheel to overheat

and possibly explode. Always grind on the sur-

faces shown in Figure

After you have switched OFF the grinder,

DO NOT continue grinding and DO NOT

manually stop the grinding wheel with your

workpiece!

To grind with the grinding wheel:

1. Fill the water cup

/4 full with water.

2. With the machine plugged into power, stand

to the side of the grinding wheel, and turn the

grinder ON.

3. Allow the machine to run for one full minute to

ensure that the grinding wheels are safe for

use, then move to the front of the machine.

4. Grasp the workpiece tightly and properly sup-

port it on the work table.

5. Place the workpiece against the surface of

the wheel with moderate pressure, moving it

back and forth in a steady, even motion.

Note

: Using too much pressure will slow the

motor, may damage the wheel, and will over-

heat the workpiece. Using too little pressure

will prevent sufficient contact with the wheel.

Figure 8. Type 50 grinding wheel surfaces.

Grinding Surfaces

Mounting Plate

1 2 ... 14 15 16 17 18 19 20 21 22 23 24 ... 31 32

Commentaires sur ces manuels

Pas de commentaire

Grizzly H7762 Manuel d'utilisateur Page 19

Commentaires sur ces manuels

Produits connexes et manuels pour Outils Grizzly H7762