Grizzly H7762 Manuel d'utilisateur télécharger pdf (Page 17)

H7762 Heavy Duty Tool Grinder

-15-

2. Align the angle gauge so that the pointer at

the bottom of the gauge is pointing at 0º.

3. Tighten the lock handle further so that the

angle gauge does not move.

4. Repeat Steps 1-3 for the other three angle

gauges.

5. Place a work table on a pair of angle gauges-

so that the bolts on the underside of the table

fit through the slots in the angle gauges.

6. Align the work table so the gap between the

table and the grinding wheel is approximately

/8".

7. Fasten the table to the support dials using an

8mm flat washer and a hex nut on each bolt,

as shown in

Figure 7.

Note:

The fastening process can affect the

gap between the work table and the grinding

wheel. Always recheck the gap width after

fastening and adjust as necessary.

8. Repeat Steps 5-7 for the other work table.

Figure 7. Work table attachment.

Angle

Gauge

Hex

Nut

Flat

Washer

1 2 ... 12 13 14 15 16 17 18 19 20 21 22 ... 31 32

Pas de commentaire

Grizzly H7762 Manuel d'utilisateur Page 17